Components Manufactured to Drawing
Components manufactured to drawing are produced strictly to your engineering drawing, with every dimension, tolerance, material, heat treatment and finish followed and inspected. It is the standard route for OEM supply and repeat production.
What it is
We review the drawing for completeness and manufacturability at quote stage, select the best process, and inspect finished parts against every requirement.
Where a change could reduce cost without affecting function, we propose it for your approval rather than changing anything ourselves.
Typical applications
- OEM components
- Repeat production parts
- Parts for new product development
- Replacement parts from existing drawings
- Assemblies from drawing packs
Materials & grades
- Steels, stainless steels and cast iron
- Aluminium, brass, bronze and copper
- Engineering plastics and rubber
Points to consider
- Send the latest drawing revision.
- Include material, general tolerances and finish notes.
- State inspection and documentation needs.
- Approved alternatives only with written consent.
Frequently asked questions
What if part of my drawing is unclear?
We raise questions at quote stage so they are resolved before production.
Do you provide inspection reports?
Yes, dimensional reports and material certificates can be supplied when requested.
Can you suggest cost savings?
Yes. We propose process or design changes for your approval where they reduce cost without affecting function.